Search
.Management Sciences
A. High dv / dt, low di / dt
B. Low dv / dt, low di / dt
C. Low dv / dt, high di / dt
D. High dv / dt, high di / dt
Related Mcqs:
- A step up chopper has input voltage 110 V and output voltage 150 V. The value of duty cycle is_____?
- A. 0.32 B. 0.67 C. 0.45 D. 0.27...
- After proper turn on of thyristor____________?
- A. gate signal is always present B. gate signal must be removed C. gate signal should present but can be removed D. none of the above....
- If the gate voltage of an SCR is removed, then the_______________?
- A. anode current decreases B. anode current does not decrease at all C. anode current increases D. cathode current increases...
- The maximum firing angle in the half wave controlled regulator is_____________?
- A. 180 degree B. 190 degree C. 200 degree D. 210 degree...
- A combination of synchronized leading edge and trailing edge modulation has also been used to control a____________?
- A. Boost single – phase power factor converter B. A buck dc – dc converter to reduce ripple in the intermediate dc bus capacitor C. Both A. and B. D. None f these...
Recent Comments