In a push – pull converter, the filter capacitor can be obtained as____________?

Power Electronics 10/07/2021

A. Cmin = V / ( Vr L f2 )
B. Cmin= ( 1 – D ) V / ( Vr L f2 )
C. Cmin= ( 1 – 2 D ) V / 32 ( Vr L f2 )
D. Cmin= ( 1 – 2 D ) V / 42 ( Vr L f2 )

Related Mcqs:

    A PNPN device having two gates is ___________?
    A. Diac B. Triac C. SUS D. BCS...
    After proper turn on of thyristor____________?
    A. gate signal is always present B. gate signal must be removed C. gate signal should present but can be removed D. none of the above....
    A string of n parallel SCRs is operated at 72 KA, the rating of each SCR is 1 KA. If derating factor of the string is 0.1. value of n will be___________?
    A. 60 B. 70 C. 80 D. 90...
    In a 3 phase CSI, if the required line output voltages are balanced and 120 degree out of phase, then the chopping angles are used to eliminate only the harmonics at frequencies
    A. 5 B. 7 C. 11 D. All of these...
    In a 3 phase half wave rectifier, when firing angle is less than 90 degree, then the average dc output voltage becomes__________________?
    A. Positive B. Negative C. Zero D. None of these...

Leave a Reply

Your email address will not be published. Required fields are marked *