During gate recovery time_____________?

Power Electronics 25/12/2021

A. charge carriers of J2 junction recombined
B. charge carriers of J2 junction is swept out
C. charge carrier of J1 junction removed
D. charge carriers of J3 junction is removed

Related Mcqs:

    The typical value of SCR for modern alternator is____________?
    A. 1.5. B. 0.5. C. 1.0. D. 1.2....
    SCR will be turned off when anode current is_______________?
    A. < latching current but greater than holding current and gate signal is 0. B. less than holding current. C. < latching current but greater than holding current and gate signal is present. D. both (A) and (B)....
    Which of the following is true about SIT?
    A. SIT is a high power, high frequency device B. SIT is a high power, low frequency device C. SIT is a high power, high voltage device D. SIT is a low power, high frequency device...
    An SCR is made up of silicon because?
    A. silicon has large leakage current than germanium B. silicon has small leakage current than germanium C. silicon has small leakage voltage than germanium D. silicon has large leakage voltage than germanium...
    For similar carrier and modulating signals, the line current used in CSI is__________?
    A. Identical to line voltage in a VSI B. Identical to line current in VSI C. Identical to phase voltage in VSI D. Identical to phase voltage in CSI...

Leave a Reply

Your email address will not be published. Required fields are marked *