A crowbar is a circuit which is used to protect a_____________?

Power Electronics 28/01/2021

A. voltage sensitive load from excessive dc power supply output voltages
B. current sensitive load from excessive dc power supply output voltages
C. voltage sensitive load from excessive ac power supply output voltages
D. current sensitive load from excessive ac power supply output voltages

Related Mcqs:

    Which of the following is used in heat sink_____________?
    A. Iron B. Aluminium C. Carbon D Silver...
    In a single phase full wave rectifier, during blocking state the pea inverse voltage of diode is______________?
    A. V m B. 2 V m C. V m / 2 D. 4 V m...
    The maximum firing angle in the half wave controlled regulator is_____________?
    A. 180 degree B. 190 degree C. 200 degree D. 210 degree...
    If energy is taken from the AC side of the inverter and sends it back into the DC side, then it is known as___________?
    A. Motoring mode operation B. Braking mode operation C. Regenerative mode operation D. None of these...
    During the commutation period in 3 phase converter, overlap time is____________?
    A. Dependent on the load current B. Dependent on the voltage C. Dependent on both the load current and load voltage behind the short circuit current D. Independent on both the load current and load voltage...

Leave a Reply

Your email address will not be published. Required fields are marked *