Which of the following component is usually fabricated out of silicon steel ?

Related Mcqs:

In Ns is the synchronous speed and s the slip, then actual running speed of an induction motor will be___________?

A. Ns B. s.N, C. (l-s)Ns D. (Ns-l)s...

DOL starting of induction motors is usually restricted to_____________?

A. low horsepower motors B. variable speed motors C. high horsepower motors D. high speed motors...

If a 3-phase supply is given to the stator and rotor is short circuited rotor will move___________?

A. in the opposite direction as the direction of the rotating field B. in the same direction as the direction of the field C. in any direction depending upon phase squence of supply...

An induction motor can run at synchronous speed when____________?

A. it is run on load B. it is run in reverse direction C. it is run on voltage higher than the rated voltage D. e.m.f. is injected in the rotor circuit...

For driving high inertia loads best type of induction motor suggested is_____________?

A. slip ring type B. squirrel cage type C. any of the above D. none of the above...