Search
.Management Sciences
A. 60 to 90%
B. 80 to 90%
C. 95 to 98%
D. 99%
Related Mcqs:
- Which of the following component is usually fabricated out of silicon steel ?
- A. Bearings B. Shaft C. Statorcore D. None of the above...
- In three-phase squirrel-cage induction motors____________?
- A. rotor conductor ends are short-circuited through slip rings B. rotor conductors are short-circuited through end rings C. rotor conductors are kept open D. rotor conductors are connected to insulation...
- Low voltage at motor terminals is due to____________?
- A. inadequate motor wiring B. poorely regulated power supply C. any one of the above D. none of the above...
- Which is of the following data is required to draw the circle diagram for an induction motor ?
- A. Block rotor test only B. No load test only C. Block rotor test and no-load test D. Block rotor test, no-load test and stator resistance test...
- The circle diagram for an induction motor cannot be used to determine____________?
- A. efficiency B. power factor C. frequency D. output...
Recent Comments