Voltage Series feedback also called series-shunt feedback) results in__________?

Analog Electronics 14/10/2024

A. Increase in both input & output impedances
B. Decreases in both input & output impedances
C. Increase in input impedance & decreases in output impedance
D. Decrease in input impedance & increase in output impedance

Related Mcqs:

    A 741-type OP-AMP has a gain-bandwidth product of 1MHz. A non-inverting amplifier using this op-amp & having a voltage gain of 20db will exhibit -3db bandwidth of__________?
    A. 50 KHz B. 100KHz C. 1000/17 KHz D. 1000/7.07 KHz...
    A differential amplifier is invariably used in the i/p stage of all OP-amps. This is done basically to provide the OP-amps with a very high_________?
    A. CMMR B. Bandwidth C. Slew rate D. Open-loop gain...
    In a full-wave rectifier using two ideal diodes,Vdc & Vm are the dc & peak values of the voltage respectively across a resistive load. If PIV is the peak inverse voltage of the diode, then the appropriate relationships for this rectifier is____________?
    A. Vdc = Vm/π, PIV=2Vm B. Vdc = 2Vm/π, PIV=2vm C. Vdc = 2Vm/π, PIV=Vm D. Vdc = Vm/π, PIV=Vm...
    The MOSFET switch in its on-state may be considered equivalent to_____________?
    A. resistor B. inductor C. capacitor D. battery...
    An npn BJT has gm=38mA/v, cµ =10¯14 F, cπ =10¯13F and DC current gain β0=90.For this transistor fT & fβ are________?
    A. fT =1.64 x 108 Hz & fβ = 1.47 x 1010 Hz. B. fT =1.47 x 1010 Hz & fβ = 1.64 x 108 Hz C. fT =1.33 x 1012 Hz & fβ = 1.47 x 1010 Hz D. fT =1.47 x 1010 Hz & fβ = 1.33 x 1012 Hz...

Leave a Reply

Your email address will not be published. Required fields are marked *