Search
.Management Sciences
A. Oxidizing zone
B. Reducing zone
C. Combustion zone
D. None of the above
Related Mcqs:
- Incomplete casting is the result of_____________?
- A. More porous investment in the mould B. Narrow sprue diameter C. Hollow sprue pin D. Large reservoir...
- Disadvantage of having a short sprue is________________?
- A. Rapid solidification of metal B. No place for reservoirs C. Incomplete evacuation of gases D. Difficulty in removing casting from investment...
- During soldering, the solidus temperature of the filler material should be_____________?
- A. Greater than the substrate material B. Lesser than the substrate material C. Equal to the substrate material D. Temperature not relevant...
- The linear solidification shrinkage of Type IV Ni-Cr based alloys is_______________?
- A. 2.3% B. 1.56% C. 1.37% D. 3%...
- Localised shrinkage porosity is seen when there________________?
- A. Thin sprue B. No reservoir C. Investment heated strongly D. Inadequate air discharge...
Recent Comments