Sub surface porosity can be decreased by_______________?

Metallurgy 27/11/2021

A. Decreasing the sprue length
B. Decreasing the sprue thickness
C. Increasing the melting temperature
D. Increasing the mould temperature

Related Mcqs:

    Tublulence of molten gold is due to _____________?
    A. Impurities in gold B. Improper venting C. A and B D. None of the above...
    Within an hour after cementation of cast gold onlay patient complains of shooting pain every time the teeth comes together Most probable explanation is ______________?
    A. Supracocclusion of restoration B. Retained cement in gingival sulcus C. Excess acid in mix D. Galvanic current caused by gold onlay occluding with a large restoration...
    Which of the following fuel gases used for soldering, has the highest heat content______________?
    A. Hydrogen B. Natural gas C. Acetylene D. Propane...
    Suck back porosity is due to_________________?
    A. Attached impurities on undersurface of casting B. Hot spot C. No rapid cooling D. Inadequate melting temperature...
    Which one of the following is most elastic ?
    A. a titanium B. B titanium C. Chrome-cobalt-nickel D. Nickel-titanium...

Leave a Reply

Your email address will not be published. Required fields are marked *