At any point of a beam, the section modulus may be obtained by dividing the moment of inertia of the section by_________________?

Related Mcqs:

The degree of indeterminacy of the frame in the given figure, is______________?

A. Zero B. 1 C. 2 D. 3...

The force in EC of the truss shown in the given figure, is__________________?

A. Zero B. 5t tension C. 5t compression D. 4t tension...

The stiffness of the close coil helical spring is_________________?

A. d4N/8D3n B. d4N/4D3n C. 4D3N/d4n D. 8D3N/d4n...

A simply supported rolled steel joist 8 m long carries a uniformly distributed load over it span so that the maximum bending stress is 75 N/mm². If the slope at the ends is 0.005 radian and the value of E = 0.2 × 106 N/mm2, the depth of the joist, is________________?

A. 200 mm B. 250 mm C. 300 mm D. 400 mm...

Pick up the correct statement from the following_______________?

A. The structural member subjected to compression and whose dimensions are small as B. compared to its length, is called a stmt The vertical compression members are generally known as columns or stanchions C. Deflection in lateral direction of a long column, is generally known as buckling D. All the above...