The design of heel slab of a retaining wall is based on the maximum bending moment due to______________?

Related Mcqs:

The minimum clear cover for R.C.C. columns shall be_________________?

A. Greater of 40 mm or diameter B. Smaller of 40 mm or diameter C. Greater of 25 mm or diameter D. Smaller of 25 mm or diameter...

If the tendon is placed at an rectangular beam (sectional top edge)________________?

A. Is increased by PZ/e B. Is increased by Pe/Z C. Is decreased by Pe/Z D. Remains unchanged...

The diameter of transverse reinforcement of columns should be equal to one-fourth of the diameter of the main steel rods but not less than________________?

A. 4 mm B. 5 mm C. 6 mm D. 7 mm...

The diameter of main bars in R.C.C. columns, shall not be less than________________?

A. 6 mm B. 8 mm C. 10 mm D. 12 mm...

If K is a constant depending upon the ratio of the width of the slab to its effective span l, x is the distance of the concentrated load from the nearer support, bw is the width of the area of contact of the concentrated load measured parallel to the supported edge, the effective width of the slab be is_______________?

A. K/x (1 + x/d) + bw B. Kx (1 – x/l) + bw C. Kx (1 + x/l) + bw D. All the above...