Flow at constant rate through a tapering pipe is________________?

Fluid Mechanics 25/09/2021

1. steady flow
2. uniform flow
3. unsteady flow
4. non-uniform flow
The correct answer is?

A. (1) and (2)
B. (1)and(iv)
C. (2) and (3)
D. (2) and (4)

Related Mcqs:

    Size of a venturimeter is specified by________________?
    A. pipe diameter B. throat diameter C. angle of diverging section D. both pipe diameter as well as throat diameter...
    If a sphere of diameter 1 cm falls in castor oil of kinematic viscosity 10 stokes, with a terminal velocity of 1.5 cm/sec, the coefficient of drag on the sphere is________________?
    A. less than 1 B. between 1 and 100 C. 160 D. 200...
    The ratio of average velocity to maximum velocity for steady laminar flow in circular pipes is_______________?
    A. 1/2 B. 2/3 C. 3/2 D. 2...
    Due to each end contraction, the discharge of rectangular sharp crested weir is reduced by________________?
    A. 5% B. 10% C. 15% D. 20%...
    An ideal fluid is_______________?
    A. one which obeys Newton’s law of viscosity B. frictionless and incompressible C. very viscous D. frictionless and compressible...

Leave a Reply

Your email address will not be published. Required fields are marked *