Generally the purlins are placed at the panel points so as to avoid__________________?

Related Mcqs:

According to IS Specifications, the maximum pitch of rivets in compression is_____________________?

A. lesser of 200 mm and 12 t B. lesser of 200 mm and 161 C. lesser of 300 mm and 32 t D. lesser of 3 00 mm and 24 t where t is thickness of thinnest outside plate or angle...

The use of tie plates in laced columns is_________________?

A. prohibited B. not prohibited C. permitted at start and end of lacing system only D. permitted between two parts of the lacing...

Hudson’s formula gives the dead weight of a truss bridge as a function of_________________?

A. bottom chord area B. top chord area C. effective span of bridge D. heaviest axle load of engine...

Which of the following conditions is to be satisfied both in elastic and plastic analysis ?

A. equilibrium condition B. yield condition C. plastic moment condition D. mechanism condition...

compression force in two end posts The pin of a rocker bearing in a bridge is designed for_________________?

A. bearing and shear B. bending and shear C. bearing and bending D. bearing, shear and bending...