If the eccentricity ratio is more than 1/24, then increase in the permissible stress in the design of wall subjected to eccentric loading as per code is_________________?

Related Mcqs:

Minimum compressive strength in N/mm2 for H1 type mortar used for masonry is_______________?

A. 3 B. 5 C. 7.5 D. 10...

For earthquake resistant masonry buildings, the vertical distance between openings one above the other in a load bearing wall shall not be less than_________________?

A. 50 cm B. 60 cm C. 75 cm D. 100 cm...

Cement mortars richer than 1 : 3 are not used in masonry because_________________?

i) there is no gain in strength of masonry ii) there is high shrinkage iii) they are prone to segregation select the correct statements? A. Only (ii) is correct B. (i) and (ii) are correct C. (ii) and (iii) are correct D. (i), (ii) and (iii) are correct...

Consider the following statements regarding bands to be provided for strengthening masonry work in masonry buildings constructed in zone III, IV and V?

(i) Lintel band is provided at lintel level on partition walls, (ii) Gable band is provided at top of gable masonry below the purlins, (iii) The bands shall be to full width of the wall and not less than 7.5 cm in depth, (iv) The bands shall be made of reinforced concrete only. the correct … Consider the following statements regarding bands to be provided for strengthening masonry work in masonry buildings constructed in zone III, IV and V?Read More...

Maximum slenderness ratio of load bearing walls for a dwelling having more than 2 storeys________________?

i) shall not exceed 12 if lime mortar is used ii) shall not exceed 18 if cement lime mortar 1:2:9 is used iii) shall not exceed 24 if cement mortar 1:6 is used the correct statments is ? A. (i) and (ii) are correct B. (ii) and (iii) are correct C. (i) and (iii) are … Maximum slenderness ratio of load bearing walls for a dwelling having more than 2 storeys________________?Read More...