Full restraint is provided by__________________?

Design of Masonry Structures 29/11/2020

i) foundation footing of a wall
ii) timber floor spanning on the wall and anchored to the wall
iii) RCC slab with a minimum bearing of 10 cm on the wall
select the correct statment.

A. (i) and (iii) are correct
B. (i) and (ii) are correct
C. (ii) and (iii) are correct
D. (i), (ii) and (iii) are correct

Related Mcqs:

    A free standing brick wall 20 cm thick is subjected to a wind pressure of 75kg/m2. The maximum height of wall from stability consideration is___________________?
    A. 0.64 m B. 0.96 m C. 1.28 m D. 1.5 m...
    If the eccentricity ratio is more than 1/24, then increase in the permissible stress in the design of wall subjected to eccentric loading as per code is_________________?
    A. 10% B. 25% C. 33 1/3% D. 50%...
    For strengthening a 50 m long and 5 m high straight compound wall built in brick work, which one of the following would be most suitable?
    A. providing buttresses at certain intervals B. providing a deeper foundation C. using a richer mortar D. using stronger bricks...
    The bending stress in a wall or column subjected to effective vertical load need not be considered, if the eccentricity ratio is_________________?
    A. less than or equal to 1/24 B. less than or equal to 1/6 C. more than 1/24 D. less than or equal to 1/12...
    If the ratio of center to center spacing of intersecting walls to actual thickness of intersecting wall is more than 20, then the stiffening coefficient for wall proper will be_________________?
    A. 0 B. between 0 and 1 C. 1 D. greater than 1...

Leave a Reply

Your email address will not be published. Required fields are marked *