Search
.Management Sciences
1. top face parallel to the wall
2. top face perpendicular to the wall
3. bottom face paralleUo the wall
4. bottom face perpendicular to the wall
The correct answer is ?
A. only (2) is correct
B. (1) and (2)are correct
C. (3) and (4) are correct
D. only (4) is correct
Related Mcqs:
- Admixtures which cause early setting, and hardening of concrete are called_______________?
- A. workability admixtures B. accelerators C. retarders D. air entraining agents...
- For concreting of heavily reinforced sections without vibration, the workability of concrete expressed as compacting factor should be________________?
- A. 0.75-0.80 B. 0.80-0.85 C. 0.85 – 0.92 D. above 0.92...
- Critical section for shear in case of flat slabs is at a distance of_______________?
- A. effective depth of slab from periphery of column/drop panel B. d/2 from periphery of column/capital/ drop panel C. at the drop panel of slab D. at the periphery of column...
- Modulus of elasticity of steel as per IS : 456-1978 shall be taken as______________?
- A. 20 kN/cm2 B. 200 kN/cm2 C. 200kN/mm2 D. 2xl06N/cm2...
- The effect of creep on modular ratio is__________________?
- A. to decrease it B. to increase it C. either to decrease or to increase it D. to keep it unchanged...
Recent Comments