Search
.Management Sciences
A. Facilitate draining out liquid from a tray when the unit is not in operation
B. Are normally located near the overflow weir so that any delivery of liquid during operation
follows approximately the same path as the overflow fluid
C. Must be large enough (usually 1/4″ to 5/8″ dia) to prevent plugging but should not deliver
excessive amount of fluid during operation
D. All A., B. and C.
Related Mcqs:
- The type of stress developed in a metallic bar on subjecting it to a change in temperature without allowing it to be deformed is ______________ stress?
- A. Shear B. Tensile C. Compressive D. Thermal...
- For laminar flow (NRe < 2100) in steel pipe, the optimum inside pipe diameter is given by____________________?
- A. Di, opt = 3 Q0.36 ρ0.18 B. Di, opt = 3.9 Q0.45 ρ0.23 C. Di, opt = 7.6 Q0.36 ρ0.9 D. Di, opt = 3 Q0.36 ρ1.86 μ0.08...
- Tube side heat transfer co-efficient for turbulent flow of liquid through tubes is proportional to___________________?
- A. G0.2 B. G0.5 C. G0.8 D. G1.5...
- Which of the following is not a graphical method (but is an analytical method) for the calculation of theoretical number of stages in case of continuous binary distillation ?
- A. Sorel-Lewis method B. McCabe-Thiele’s method C. Ponchon-Savarit method D. None of these...
- In case of 1.5″ heat exchanger tubes, the inside flow area _____________ with decrease in BWG?
- A. Increases B. Decreases C. Remains same D. None of these...
Recent Comments