Thickness of the frame of a plate and frame filter as compared to that of plates is___________________?

Related Mcqs:

For a cylindrical shell, (subject to the thickness of uppermost course being more than the minimum for dia of the tank in question), the thickness of the courses of shell_________________?

A. Decreases upwards B. Increases upwards C. Remains same throughout D. May decrease or increase upwards depending upon whether vacuum or positive pressure would be maintained inside the shell...

The ratio of the largest load in a test to the original cross-sectional area of the test specimen is called the _____________ stress?

A. Yield point B. Breaking C. Ultimate D. None of these...

The equivalent diameter for fluid flow through a channel of constant non-circular cross section of area ‘A’ is given by (where, P = perimeter of the channel in contact with the fluid) ?

A. 4 A/P B. A/P C. 4 P/A D. √A...

For identical situation, condensing film coefficient in case of a horizontal condenser is almost ______________ the value expected in case of vertical condenser?

A. Half B. Twice C. Thrice D. Five times...

In case of a shell and tube heat exchanger, the minimum shell thickness for carbon steel (inclusive of corrosion allowance) depends on shell diameter and is in the range of ________________ mm?

A. 3-5 B. 5-11 C. 8-15 D. 12-18...