Maximum acceptable total liquid gradient over a tray is about _______________ mm?

Related Mcqs:

Frame thickness in the plate and frame filter press is normally in the range of ______________ inches?

A. 0.25 to 4 B. 0.25 to 8 C. 1 to 5 D. 1 to 12...

A cylindrical pressure vessel of volume 6 πm3 has to be designed to withstand a maximum internal pressure of 10 atm. The allowable design stress of the material is 125N/mm2 and corrosion allowance is 2 mm. The thickness of the vessel for a length/diameter ratio of 3 will be close to________________?

A. 5 mm B. 6 mm C. 8 mm D. 10 mm...

Vertical vessels are not supported by____________________?

A. Brackets B. Skirts C. Columns D. Saddles...

The shell side pressure drop in a shell and tube heat exchanger is maximum for _______________ baffle?

A. Disk and ring B. Segmental C. Orifice D. Independent of the type of...

Pick out the wrong statement about the design of sieve plate column and the bubble cap column ?

A. The downcomer design and the residence time in the downcomer is almost same for sieve plate and bubble cap columns B. Weir length for a bubble cap plate is the same as that for the sieve plate C. Weir height for a bubble cap plate column is the same as that for a sieve … Pick out the wrong statement about the design of sieve plate column and the bubble cap column ?Read More...