LMTD correction factor is used in heat exchanger design for____________________?

Related Mcqs:

Practical dividing line between a ductile and brittle materials is suggested, when the ultimate elongation is about 5%. Generally, larger the knuckle radius, stronger is the corner torus section of a head. The knuckle radius provided should be less than ______________ of the head?

A. 6% of I.D. B. 3 times the thickness C. Either A. or B., whichever is larger D. Either A. or B., whichever is smaller...

The dust collection efficiency of a cyclone separator_________________?

A. Decreases with increase in gas flow rate B. Is inversely proportional to the mass of the dust particle C. Is directly proportional to the radius of the dust particle path D. None of these...

The thermal stress in a metallic bar does not depend upon the_____________________?

A. Changes in temperature B. Cross-sectional area C. Both A. and B. D. Neither A. nor B....

With increase in pressure drop (for a given particle size), the dust collection efficiency of a cyclone separator will________________?

A. Increase B. Decrease C. Remain unaffected D. Increase or decrease depending on the nature of the dust...

An under-designed steam trap will___________________?

A. Waste steam B. Destroy itself of acceleration wear due to rapid recycling C. Back up condensate and cause water hammer in steam line D. None of these...