Cylindrical pressure vessels in horizontal condition is generally supported on a ________________ support?

Related Mcqs:

In case of a ‘thin’ pressure vessel, the ratio of its diameter to wall thickness is_________________?

A. < 10 B. > 10 C. > 20 D. 30...

The clearance between two tubes in a shell and tube heat exchanger is known as ‘ligament’, whose minimum value is _____________ the outside diameter of the tube, but in no case it should be less than 4.5 mm?

A. Equal to B. Half C. One fourth D. Three fourth...

Pick out the wrong statement ?

A. Plate efficiency increases with increase in superficial vapour velocity till entrainment limit B. Increase in depth of the liquid about the slots increases the plate efficiency, particularly if the liquid depth is < 1" C. Too small a plate spacing can cause a low efficiency, if the vapour velocity is greater than the allowable … Pick out the wrong statement ?Read More...

Rotary driers are most economically designed for the number of heat transfer units (HTU) from _________________?

A. 0.01 to 1 B. 1.5 to 2.5 C. 5 to 10 D. 10 to 20...

Width and depth of grooves in the tube sheet holes normally are _______________ inch respectively?

A. 1/8 and 1/64 B. 1/64 and 1/8 C. 1/2 and 8 D. 1/2 and 5...