Typical specifications for design stipulates the gain margin and phase margin to be respectively__________________?

Related Mcqs:

Stabilising time for the controllers is the time required for the response to reach _____________ percent of its ultimate value?

A. 63.2 B. 87.5 C. 95 D. 100...

Flow rate measurement of hostile acids and alkalis can be most suitably done by a/an ________________?

A. Venturimeter B. Orificemeter C. Magnetic flow meter D. Hot wire anemometer...

Smoke density of the flue gas going out of the chimney is measured by a __________________?

A. Polarograph B. Thermal conductivity meter C. Photo electric cell D. Chromatograph...

The characteristic equation for the control system with a closed loop transfer function G1/1 + G2 is given by 1 + G2 = 0. The characteristic equation for the control system_________________?

A. Depends only upon the open loop transfer function B. Determines its stability C. Is the same for set point or load changes D. All A , B & C....

The amplitude ratio for the sinusoidal response of a _____________ is 1?

A. First order system B. Second order system C. Transportation lag D. None of these...