Half the angle of nip, (α), for a roll crusher is given by (where, dr, dp and df are diameters of crushing rolls, feed particles and rolls gap respectively) ?

Mechanical Operations 01/08/2020

A. cos α = (dr + dp)/(dr + df)
B. cos α = (dr + df)/(dr + dp)
C. tan α = (dr + dp)/(dr + df)
D. sin α = (dr + dp)/(dr + df)

Related Mcqs:

    Which of the following agitators having a large blade area, rotating at slow speed is used for mixing high viscosity liquids (> 50000 centipoise) ?
    A. Propeller B. Helical screw C. Flat blade turbine D. Curved blade turbine...
    General crushing equation is given by d(P/m) = -K (dD̅ S/D̅ n S). Bond’s crushing law is obtained by solving this equation for n = _____________ and feed of infinite size?
    A. 1 B. 1.5 C. 2 D. 2.5...
    A fluid energy mill is used for __________________?
    A. Cutting B. Grinding C. Ultra-grinding D. Crushing...
    For sizing of fine materials, the most suitable equipment is a____________________?
    A. Trommel B. Grizzly C. Shaking screen D. Vibrating screen...
    Which of the following terminology is not used for size reduction of materials to fine sizes or powders ?
    A. Comminution B. Dispersion C. Pulverisation D. Compression...

Leave a Reply

Your email address will not be published. Required fields are marked *