To get high tray efficiency___________________?

Mass Transfer 14/08/2024

A. Interfacial surface between liquid and gas phase should be large
B. Time of contact between the two phases should be less
C. Gas velocity should be very low
D. Liquid entrainment should be severe

Related Mcqs:

    H2S is being absorbed in a gas absorber unit. The height of the transfer unit based on the overall mass transfer coefficient on the gas side is 0.4 m. The equilibrium data is given by, y = 1.5 x. The bulk concentration of H2S has to be reduced from 0.05 to 0.001 mole fraction in the gas side. The height of the tower (in meters) corresponding to an operating line given by, y = 5x + 0.001 is ______________________?
    A. 2.0 B. 1.56 C. 1.0 D. 0.56...
    Which of the following mixtures does not form an azeotrope at atmospheric pressure ?
    A. Water-alcohol B. Methyl alcohol-acetone C. Butyl acetate-water D. None of these...
    When the liquid over a plate is of uniform concentration, then ______________________?
    A. Murphree efficiency > point efficiency B. Murphree efficiency < point efficiency C. Murphree efficiency = point efficiency D. Murphree efficiency ≠ point efficiency...
    An Azeotropic mixture is a ________________ mixture?
    A. Binary B. Ternary C. Constant boiling point D. None of these...
    For contacting a highly soluble gas with a liquid ____________________?
    A. Bubble the gas through liquid B. Spray the liquid on gas stream C. Either A. or B. would suffice D. None of these...

Leave a Reply

Your email address will not be published. Required fields are marked *