In liquid extraction, if the selectivity is unity, then___________________?

Related Mcqs:

Experiments were conducted to determine the flux of a species A in a stagnant medium across a gas-liquid interface. The overall mass transfer co-efficient based on the liquid side for dilute systems for the above was estimated to be 4 × 10-3 kg mole/m2.s. The equilibrium data for the system is given as y = 2x. The flux across the interface (in kg mole/m2 .s) for bulk concentrations of A in gas phase and liquid phase as y = 0.4 and x = 0.01 respectively is _________________________?

A. 5.6 × 10-4 B. 8.5 × 10-4 C. 5.6 × 10-3 D. 8.5 × 10-3...

Pick out the wrong statement ?

A. Absorption factor is constant, when the equilibrium and operating lines are straight B. In case of a stripper, the equilibrium curve is always below the operating line C. In case of an absorber, the operating line is always above the equilibrium curve D. In the absorption of low solubility gases, the liquid film is … Pick out the wrong statement ?Read More...

Pick out the wrong statement ?

A. In solvent extraction, the distribution co-efficient should be as large as possible for solvent economy B. With increase in pressure, the solubility of gases in solvent increases at a fixed temperature C. Decrease in Murphree plate efficiency is an indication of entrainment in distillation column D. The capacity of a distillation column is maximum … Pick out the wrong statement ?Read More...

In liquid extraction, if the selectivity is unity, then__________________?

A. Separation of the constituents is the most effective B. No separation will occur C. Amount of solvent required will be minimum D. Solvent flow rate should be very low...

In a binary distillation column, if the feed contains 40 mole % vapour, the q line will have a slope of_________________?

A. 1.5 B. -0.6 C. -1.5 D. 0.6...