H2S is being absorbed in a gas absorber unit. The height of the transfer unit based on the overall mass transfer coefficient on the gas side is 0.4 m. The equilibrium data is given by, y = 1.5 x. The bulk concentration of H2S has to be reduced from 0.05 to 0.001 mole fraction in the gas side. The height of the tower (in meters) corresponding to an operating line given by, y = 5x + 0.001 is ______________________?

Related Mcqs:

A natural draft cooling tower is filled with wooden grids, which covers about _________________ percent of the tower height?

A. 10-15 B. 30-40 C. 70-80 D. 90-100...

For gas absorption, low viscosity solvents are preferred, because of their ____________________?

A. Better flow characteristics B. Low pumping pressure drop C. Rapid absorption rates D. All A., B. and C....

Can the efficiency of a plate in the distillation tower be greater than 100% ?

A. Yes B. Normally not; but is possible if infinite number of plates are put C. Never D. Yes; if the reflux ratio is maximum...

To get high tray efficiency___________________?

A. Interfacial surface between liquid and gas phase should be large B. Time of contact between the two phases should be less C. Gas velocity should be very low D. Liquid entrainment should be severe...

Which of the following is not a batch drier ?

A. Truck drier B. Agitated pan drier C. Fluidised bed drier D. Vacuum shelf drier...