Which of the following situations can be approximated to a steady state heat transfer system ?

Related Mcqs:

What is the geometric mean of two heat transfer areas A1 and A2 ?

A. √(A1 . A2) B. √(A1 + A2) C. ½ √(A1 . A2) D. 2 √(A1 . A2)...

Overall heat transfer co-efficient of a particular tube is U1. If the same tube with some dirt deposited on either side has coefficient U2, then_________________?

A. U1 = U2 B. U2 > U1 C. U1 > U2 D. U1 = dirt factor – U2...

It is desired to concentrate a 20% salt solution (20 kg of salt in 100 kg of solution) to a 30% salt solution in an evaporator. Consider a feed of 300 kg/min at 30°C. The boiling point of the solution is 110°C, the latent heat of vaporisation is 2100 kJ/kg and the specific heat of the solution is 4 kJ/kg.K. The rate at which the heat has to be supplied in (kJ/min) to the evaporator is____________________?

A. 3.06 × 105 B. 6.12 × 105 C. 7.24 × 105 D. 9.08 × 105...

Kirchoff’s law is applicable to________________?

A. Monochromatic radiation only B. Total radiation only C. Both A. and B. D. Only volumes and not to surfaces...

A 10 cm dia steam pipe, carrying steam at 180°C, is covered with an insulation (conductivity = 0.6 W/m.°C). It losses heat to the surroundings at 30°C. Assume a heat transfer co-efficient of 0.8 W/m2.°C for heat transfer from surface to the surroundings. Neglect wall resistance of the pipe and film resistance of steam. If the insulation thickness is 2 cms, the rate of heat loss from this insulated pipe will be__________________?

A. Greater than that for un-insulated steam pipe B. Less than that of the un-insulated steam pipe C. Equal to that of the un-insulated steam pipe D. Less than the steam pipe with 5 cms insulation...