View factor is important in heat transfer by_____________________?

Related Mcqs:

Fouling factor for a heat exchanger is given by (where, U1 = heat transfer co-efficient of dirty surface U2 = heat transfer co-efficient of clean surface) ?

A. U1 – U2 B. 1/U1 – 1/U2 C. 1/U2 – 1/U1 D. U2 – U1...

Nucleate boiling is promoted ___________________?

A. On polished surfaces B. On rough surfaces C. In the absence of agitation D. None of these...

The inner wall of a furnace is at a temperature of 700°C. The composite wall is made of two substances, 10 and 20 cm thick with thermal conductivities of 0.05 and 0.1 W.m-1.°C- 1 respectively. The ambient air is at 30°C and the heat transfer co-efficient between the outer surface of wall and air is 20 W.m-2.°C-1. The rate of heat loss from the outer surface in W.m-2is__________________?

A. 165.4 B. 167.5 C. 172.5 D. 175...

Stefan-Boltzmann law applies to _____________ body?

A. Black B. White C. Grey D. Any colour...

In case of a multipass shell and tube heat exchanger, the temperature drop in the fluid _______________?

A. Is inversely proportional to the resistance across which the drop occurs B. And the wall are proportional to individual resistances C. And the wall is not related D. None of these...