The purpose of providing bleed points in the evaporator is to__________________?

Chemical Heat Transfer 09/08/2021

A. Admit the feed
B. Remove the product
C. Facilitate removal of non-condensable gases
D. Create vacuum

Related Mcqs:

    At what value of Prandtl number, conduction is negligible in the turbulent core of a fluid flowing through a heated pipe ?
    A. 0.5 B. < 0.5 C. > 0.6 D. < 0.1...
    A single pass air heater is connected to a two pass unit. For the air flow rate and other conditions remaining the same, the film heat transfer co-efficient for air will vary in the ratio of__________________?
    A. 2 B. 20.8 C. 20.2 D. 20.5...
    In SI units, thermal conductivity is expressed in__________________?
    A. Watt/m.°K B. Watt/m2. °K C. Watt/m2. °K D. Watt/m4. °K...
    The heat transfer co-efficient in film type condensation is _______________ that for dropwise condensation?
    A. Greater than B. Lower than C. Is same as D. Half...
    In forced convection, the heat transfer depends on _______________?
    A. Re, Pr B. Re, Gr C. Mainly Gr D. Re only...

Leave a Reply

Your email address will not be published. Required fields are marked *