A centrifugal pump loses prime after starting. The reason of this trouble may be_____________________?

Fluid Mechanics for Chemical 29/10/2021

A. Incomplete priming
B. Too high a suction lift
C. Low available NPSH and air leaks in the suction pipe
D. All A., B., and C.

Related Mcqs:

    Which is the most efficient and best for measuring very small flow rate of gases ?
    A. Venturimeter B. Orificemeter C. Rotameter D. Flow nozzle...
    Pick out the wrong statement?
    A. A fluid mass is free from shearing forces, when it is made to rotate with a uniform velocity B. Newton’s law of viscosity is not applicable to the turbulent flow of fluid with linear velocity distribution C. Laminar flow of viscous liquids is involved in the lubrication of various types of bearings D. Rise … Pick out the wrong statement?Read More...
    With the increase in depth, the hydrostatic pressure in an un-accelerated incompressible fluid (in a constant gravitational field) ?
    A. Decreases B. Increases linearly C. Increases exponentially D. Remain constant...
    Plunger pumps are used for__________________?
    A. Higher pressure B. Slurries C. Viscous mass D. None of these...
    Correction for capillary effect in manometers (used for pressure measurement) need not be applied, if diameter of the manometer tube is _____________ mm?
    A. 4 C. > 12.5 D. < 10...

Leave a Reply

Your email address will not be published. Required fields are marked *