Pick out the wrong statement?

Chemical Heat Transfer 24/06/2021

A. The capacity of an evaporator is reduced by the boiling point elevation
B. Corrosive liquid is normally passed through the tubes in a shell and tube heat exchanger
C. Steam jet ejector is used for vapor compression in a thermal recompression evaporator
D. Heat sensitive materials should be concentrated in high pressure evaporators

Related Mcqs:

    “The ratio of the total emissive power to the absorptivity for all bodies is same at ther-mal equilibrium”. This is ______________ law?
    A. Kirchoff’s B. Planck’s C. Wien’s displacement D. Stefan-Boltzmann...
    Indirect contact heat exchangers are preferred over direct contact heat exchangers, because_________________?
    A. Heat transfer co-efficient are high B. There is no risk of contamination C. There is no mist formation D. Cost of equipment is lower...
    In a co-current double pipe heat exchanger used for condensing saturated steam over the inner tube, if the entrance and exit conditions of the coolant are interchanged, then the rate of condensation will___________________?
    A. Increase B. Decrease C. Remain unchanged D. Either increase or decrease; depends on the coolant flow rate...
    For hot feed, forward feeding as compared to backward feeding results in ______________ economy?
    A. Increased B. Decreased C. No effect on D. None of these...
    The main purpose of providing fins on heat transfer surface is to increase the_________________?
    A. Temperature gradient B. Mechanical strength of the equipment C. Heat transfer area D. Heat transfer co-efficient...

Leave a Reply

Your email address will not be published. Required fields are marked *