‘Flare tower’ used in industry is meant for_____________________?

Chemical Engineering Basics 05/09/2020

A. Venting off (after burning) the excess inflammable/toxic gases at high pressure
B. Absorbing the pollutant gases from the furnace exhaust
C. Cooling of furnace exhaust gases
D. None of these

Related Mcqs:

    A pycnometer is used for the measurement of________________________?
    A. Flow rate of molten metal B. Specific gravity of a liquid C. Composition of alloys D. Concentration of a solution...
    Nusselt number is related to Grashoff number (Gr) in turbulent & laminar flow respectively, in respect of free convection over a vertical flat plate as_________________?
    A. Gr0.25, Gr B. Gr0.25, Gr0.33 C. Gr, Gr0.25 D. Gr0.33, Gr0.25...
    The best guide to judge the general quality of water is the measurement of its__________________?
    A. pH value B. Electrical conductivity C. Turbidity D. Dissolved oxygen content...
    Use of economiser in a boiler plant reduces the fuel consumption for steam generation by about _______________ percent ?
    A. 1 B. 10 C. 30 D. 50...
    A jig is used while __________________ a hole?
    A. Boring B. Counter boring C. Drilling D. Enlarging...

Leave a Reply

Your email address will not be published. Required fields are marked *