A steel beam supporting loads from the floor slab as well as from wall is termed as________________?

Related Mcqs:

According to IS Specifications, the maximum pitch of rivets in compression is_____________________?

A. lesser of 200 mm and 12 t B. lesser of 200 mm and 161 C. lesser of 300 mm and 32 t D. lesser of 3 00 mm and 24 t where t is thickness of thinnest outside plate or angle...

The slenderness ratio of lacing bars should not exceed________________?

A. 100 B. 120 C. 145 D. 180...

The sway bracing is designed to transfer____________________?

A. 2Vi % of the top panel wind load to bottom bracing B. 10% of the top panel wind load to bottom bracing C. 25% of the top panel wind load to bottom bracing D. 50% of the top panel wind load to bottom bracing...

For rivets in tension with counter-sunk heads, the tensile value shall be____________________?

A. reduced by 25 % B. reduced by 33.3% C. increased by 25 % D. increased by 33.3 %...

The external wind pressure acting on a roof depends on__________________?

A. degree of permeability of roof B. slope of roof C. both (A) and (B) D. none of the above...