Where a structural component or a system is providing lateral support to five or more walls or columns, the lateral load to be resisted may be taken as_______________?

Related Mcqs:

If the eccentricity ratio is more than 1/24, then increase in the permissible stress in the design of wall subjected to eccentric loading as per code is_________________?

A. 10% B. 25% C. 33 1/3% D. 50%...

The mode of failure of a very short masonry member having h/t ratio of less than 4 is by _______________?

A. shear B. vertical tensile splitting C. buckling D. any of the above...

For masonry built in 1:1:6 cement-lime-sand mix mortar or equivalent, the horizontal shear stress permissible on the area of a mortar bed joint is_______________?

A. 0.15 MPa B. 0.125 MPa C. 0.1 MPa D. 0.075 MPa...

If the ratio of center to center spacing of intersecting walls to actual thickness of intersecting wall is more than 20, then the stiffening coefficient for wall proper will be_________________?

A. 0 B. between 0 and 1 C. 1 D. greater than 1...

Maximum slenderness ratio of load bearing walls for a dwelling having more than 2 storeys________________?

i) shall not exceed 12 if lime mortar is used ii) shall not exceed 18 if cement lime mortar 1:2:9 is used iii) shall not exceed 24 if cement mortar 1:6 is used the correct statments is ? A. (i) and (ii) are correct B. (ii) and (iii) are correct C. (i) and (iii) are … Maximum slenderness ratio of load bearing walls for a dwelling having more than 2 storeys________________?Read More...