Spacing of stirrups in a rectangular beam, is__________________?

Related Mcqs:

The load stress of a section can be reduced by______________?

A. Decreasing the lever arm B. Increasing the total perimeter of bars C. Replacing larger bars by greater number of small bars D. Replacing smaller bars by greater number of greater bars...

If the permissible compressive and tensile stresses in a singly reinforced beam are 50 kg/cm2 and 1400 kg/cm2 respectively and the modular ratio is 18, the percentage area At of the steel required for an economic section, is__________________?

A. 0.496 % B. 0.596 % C. 0.696 % D. 0.796 %...

A reinforced concrete cantilever beam is 3.6 m long, 25 cm wide and has its lever arm 40 cm. It carries a load of 1200 kg at its free end and vertical stirrups can carry 1800 kg. Assuming concrete to carry one-third of the diagonal tension and ignoring the weight of the beam, the number of shear stirrups required, is___________________?

A. 30 B. 35 C. 40 D. 45...

The maximum shear stress (q) in concrete of a reinforced cement concrete beam is_____________?

A. Shear force/(Lever arm × Width) B. Lever arm/(Shear force × Width) C. Width/(Lever arm × Shear force) D. (Shear force × Width)/Lever arm...

The effective width of a column strip of a flat slab, is_______________?

A. One-fourth the width of the panel B. Half the width of the panel C. Radius of the column D. Diameter of the column...