In all base driver amplifiers__________?

Analog Electronics 28/05/2020

A. ac collector voltage is 180° out of phase with ac base voltage
B. ac emitter voltage is 180° out of phase with ac base voltage
C. ac collector voltage is in phase with ac base voltage
D. none of the above

Related Mcqs:

    In deriving ac equivalent circuit for an amplifier circuit, we short circuit___________?
    A. all resistors B. all transistors C. all inductors D. all capacitors...
    To prevent a DC return between source and load, it is necessary to use___________?
    A. resistor between source and load B. inductor between source and load C. capacitor between source and load D. either A. or B....
    Class AB operation is often used in power large signal amplifiers in order to_________?
    A. get maximum efficiency B. remove even harmonics C. overcome a crossover distortion D. reducing collector dissipation...
    An amplifier using an opamp with slew rate SR=1v/µsec has a gain of 40db.if this amplifier has to faithfully amplify sinusoidal signals from dc to 20 KHz without introducing any slew-rate induced distortion, then the input signal level must not exceed________?
    A. 795mV B. 395mV C. 795 mV D. 39.5mV...
    The encapsulation of transistor is necessary for__________?
    A. preventing radio interference B. preventing photo-emission effects C. avoiding loss of free electrons D. mechanical ruggedness...

Leave a Reply

Your email address will not be published. Required fields are marked *