The endurance limit in shear of carbon steel can be obtained by multiplying the endurance limit in flexure by a factor of____________?

Related Mcqs:

Stress concentration is caused due to_____________________?

A. variation in properties of material from point to point in a member B. pitting at’points or areas at which loads on a member are applied C. abrupt change of section D. all of the above E. none of the above...

Residual stress in materials_________________?

A. acts when external load is applied B. becomes zero when external load is removed C. is independent of external loads D. is always harmful E. is always beneficial...

Taper on the cotter and slot is provided_________________?

A. on both the sides B. on one side only C. on none of the sides D. may be provided anywhere E. none of the above...

Oil in journal bearing should be applied at the point where load is________________?

A. nil or lightest B. maximum C. average D. any one of the above E. unpredictable...

Form coefficient of spring is _____________________?

A. ratio of coil diameter to wire diameter B. load required to produce unit deflection C. its capability of storing energy D. concerned With strength of wire of spring E. nothing...