Search
.Management Sciences
Category: Steam Boilers, Engines, Nozzles and Turbines
The biggest size of thermal power unit operating in India is ________________?
A. 30 MW
B. 60 MW
C. 100 MW
D. 210 MW
E. 500 MW
The feed check valve is used in order to ______________________?
A. regulate flow of boiler water
B. check level of water in boiler drum
C. recirculate unwanted feed water
D. allow high pressure feed water to flow to drum and not allow reverse flow to take place
E. none of the above
The saturation temperature of steam with increase in pressure increases____________________?
A. linearly
B. rapidly first and then slowly
C. slowly first and then rapidly
D. inversely
E. none of the above
The maximum discharge through a chimney occurs when the height of chimney is_____________________?
A. infinitely long
B. around 200 meters
C. equal to the height of the hot gas column producing draught
D. outside temperature is very low
E. more than the tallest building nearby
The pressure at which latent heat of vaporisation of water is zero, is_________________?
A. below atmospheric pressure
B. 1 kg/cm2
C. 100 kg/cm2
D. 170 kg/cm2
E. 225.6 kg/cm2
A boiler in India should conform to safety regulations of__________________?
A. DIN
B. BS
C. ASTM
D. IBR
E. GOST
Spontaneous combustion is a phenomenon in which____________________?
A. all the fuel burns instantaneously producing high energy release
B. fuel burns with less air
C. coal bursts into flame without any external ignition source but by itself due to gradual increase in temperature as a result of heat released by combination of oxygen with coal
D. explosion in furnace
E. none of the above
The radius of a dished head is taken approximately as______________________?
A. one-fourth
B. half
C. one
D. two
E. three
Locomotive boiler is of the following type__________________?
A. multitubular
B. horizontal
C. internally fired
D. mobile
E. all of the above
The number of flue tubes in Lancashire boiler is_________________?
A. zero
B. one
C. two
D. four
E. many
Recent Comments