Search
.Management Sciences
Category: Surveying
After fixing the plane table to the tripod, the main operations which are needed at each plane table station are ______________ ?
1. levelling
2. orientation
3. centering
The correct sequence of these operations is
A. (1), (2),(3)
B. (1), (3), (2)
C. (3), (1), (2)
D. (2), (3), (1)
Cross staff is an instrument used for________________?
A. measuring approximate horizontal angles
B. setting out right angles
C. measuring bearings of the lines
D. none of the above
The sensitivity of a bubble tube can be increased by________________?
A. increasing the diameter of the tube
B. decreasing the length of bubble
C. increasing the viscosity of liquid
D. decreasing the radius of curvature of tube
Which of the following is not used in measuring perpendicular offsets ?
A. line ranger
B. steel tape
C. optical square
D. cross staff
The permissible error in chaining for measurement with chain on rough or hilly ground is_____________?
A. 1 in 100
B. 1 in 250
C. 1 in 500
D. 1 in 1000
The difference between a level line and a horizontal line is that_______________?
A. level line is a curved line while hori-zontal line is a straight line
B. level line is normal to plumb line while horizontal line may not be normal to plumb line at the tangent point to level line
C. horizontal line is normal to plumb line while level line may not be normal to the plumb line
D. both are same
The angle of intersection of the two plane mirrors of an optical square is______________?
A. 30°
B. 45°
C. 60°
D. 90°
A telescope is said to be inverted if its______________?
A. vertical circle is to its right and the bubble of the telescope is down
B. vertical circle is to its right and the bubble of the telescope is up
C. vertical circle is to its left and the bubble of the telescope is down
D. vertical circle is to its left and the bubble of the telescope is up
The two point problem and three point problem are methods of________________?
A. resection
B. orientation
C. traversing
D. resection and orientation
The methods used for locating the plane table stations are_______________?
1. radiation
2. traversing
3.intersection
4. resection
The correct answer is
A. (1) and (2)
B. (3) and (4)
C. (2) and (4)
D. (1) and (3)
Recent Comments