A simply supported beam which carries a uniformly distributed load has two equal overhangs. To have maximum B.M. produced in the beam least possible, the ratio of the length of the overhang to the total length of the beam, is_________________?

Related Mcqs:

The forces acting normally on the cross section of a bar shown in the given figure introduce_____________?

A. Compressive stress B. Tensile stress C. Shear stress D. None of these...

length of a column of length L, having one end fixed and other end hinged, is The equivalent_____________?

A. 2 L B. L C. L/2 D. L...

Stress may be expressed in Newtons___________________?

A. Per millimetre square (N/mm2) B. Per centimetre square (N/cm2) C. Per metre square (N/m2) D. None of these...

A steel rod of sectional area 250 sq. mm connects two parallel walls 5 m apart. The nuts at the ends were tightened when the rod was heated to 100°C. If steel = 0.000012/C°, Esteel = 0.2 MN/mm2, the tensile force developed at a temperature of 50°C, is_________________?

A. 80 N/mm2 B. 100 N/mm 2 C. 120 N/mm2 D. 150 N/mm2...

A simply supported beam carries varying load from zero at one end and w at the other end. If the length of the beam is a, the maximum bending moment will be_______________?

A. wa/27 B. wa²/27 C. w²a D. wa²...