Log mean temperature difference in case of multi-pass shell and tube heat exchanger is always_________________?

Process Equipment and Plant Design 22/10/2020

A. Less than arithmetic mean value
B. More than arithmetic mean value
C. More than geometric mean value
D. Both B. & C.

Related Mcqs:

    The longitudinal stress induced in a thin walled cylindrical vessel under internal pressure is_________________?
    A. pd/2t B. pd/4t C. pd/t D. pd/8t...
    A binary liquid Azeotropic mixture has boiling point lower than either of the components, when it shows _____________ deviation from Raoult’s Law?
    A. Positive B. Negative C. No D. None of these...
    Cooling water fouling factors vary in the range of 0.001 to 0.003____________________?
    A. (BTU/hr.ft2. °F)-1 B. (kcal/hr.m2.°C)-1 C. (W/m2.°K)-1 D. (kcal/hr. m. °C)-1...
    Equivalent diameter for heat transfer calculation for a duct of square cross-section having each side as ‘d’ will be__________________?
    A. d B. √d C. √(2πd) D. √(2d)...
    It is not desirable to design a heat exchanger for LMTD correction factor, FT, of less than _________________?
    A. 0.99 B. 0.95 C. 0.80 D. 0.55...

Leave a Reply

Your email address will not be published. Required fields are marked *